Nissan Versa

 Sedan Service Manual

Body exterior, doors, roof & vehicle security » Exterior (EXT)
Rear bumper

Exploded View

1. Rear bumper side brackets (LH) 2. Rear bumper closing (LH) 3. Rear bumper fascia 4. Rear bumper closing (RH) 5. Rear bumper side brackets (RH) 6. Rear bumper reinforcement A. Screw grommet

Removal and Installation

REMOVAL

CAUTION: Bumper fascia is made of resin. Do not apply strong force to it, and be careful to prevent contact with oil.

1. Remove rear combination lamps (LH/RH). Refer to EXL "Removal and Installation".

2. Remove clips (A) and screws (B) (LH/RH).

3. Remove rear bumper fascia lower clips.

4. Remove rear bumper fascia end screws (A).

5. Pull rear bumper fascia away as shown by the arrows in the illustration and then disengage the rear bumper fascia from rear bumper side brackets (LH/RH).

Pawl

6. Remove rear bumper fascia.

CAUTION: When removing bumper fascia assembly, two people are required to avoid damaging.

7. Remove the following parts after removing rear bumper fascia. Rear bumper side brackets (LH/RH)

8. Remove rear bumper reinforcement nuts and rear bumper reinforcement.

9. Remove rear bumper closing clips and rear bumper closings (LH/RH).

INSTALLATION

Installation is in the reverse order of removal.

NOTE: 

• The following table shows the specified values for checking normal installation specifications.
• Fitting adjustment cannot be performed.

Precautions

Squeak and rattle trouble diagnoses

Front bumper

Under cover

Rear bumper

Front grille

Cowl top

Fender protector

Roof side molding

Door outside molding

Trunk lid finisher

Door parting seal

Rear spoiler