Toyota
Nissan Versa
 Sedan Service Manual
Brakes » Brake system (BR) » Brake pedal
Removal and Installation

REMOVAL

  1. Remove instrument lower panel LH. Refer to IP "Removal and Installation".
  2. Disconnect the harness connectors from the stop lamp switch and ASCD cancel switch (if equipped).
  3. Disconnect the harness connector from the accelerator pedal.
  4. Separate the harness from brake pedal assembly.
  5. Rotate the stop lamp switch counter clockwise to remove.
  6. Rotate the ASCD cancel switch counter clockwise to remove (if equipped).
  7. Remove snap pin and clevis pin from clevis.

    CAUTION: Do not reuse the snap pin and clevis pin.

  8. Disconnect the power steering harness connector and position it aside.
  9. Remove the brake pedal assembly.

    CAUTION: Hold the brake booster and master cylinder assembly so as not to drop out or contact them other parts.

  10. Disconnect accelerator pedal from brake pedal assembly. Refer to ACC "Exploded View".
  11. Perform inspection after removal. Refer to BR "Inspection and Adjustment".

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION: Do not reuse the snap pin and clevis pin.

  • Apply the multi-purpose grease to the clevis pin and the mating faces. (Not necessary if grease has been already applied)

NOTE:

  • The clevis pin may be inserted in either direction.
  • Do not give any impact caused by dropping, interference with a tool, contact between parts or with rack to the brake pedal.
  • Do not use an part that has been subject to an impact.
  • Perform adjustment after installation. Refer to BR "Inspection and Adjustment".
    More about «Brake pedal»:

    Removal and Installation

    Inspection and Adjustment

    Nissan Versa Sedan Service Manual / Brakes / Brake system (BR) / Brake pedal / Removal and Installation

    Nissan Versa Sedan Service Manual

    Categories


    © 2017-2024 Copyright www.niveguide.com