Nissan Versa (N17): Trunk lid opener actuator

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Trunk lid opener actuator

Component Function Check

1.CHECK FUNCTION

  1. Select INTELLIGENT KEY of BCM using CONSULT.
  2. Select TRUNK/GLASS HATCH in ACTIVE TEST mode.
  3. Touch OPEN to check that it works normally.

Is the inspection result normal?

YES >> Trunk lid opener actuator is OK.

NO >> Refer to DLK "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to DLK "TRUNK LID OPENER SYSTEM : Wiring Diagram".

1.CHECK TRUNK LID OPENER INPUT SIGNAL

  1. Turn ignition switch OFF.
  2. Disconnect trunk lid lock assembly connector.
  3. Check voltage between trunk lid lock assembly harness connector and ground. 

Is the inspection result normal?

YES >> GO TO 3.

NO >> GO TO 2.

2.CHECK TRUNK LID OPENER ACTUATOR CIRCUIT

  1. Disconnect BCM connector.
  2. Check continuity between BCM harness connector and trunk lid lock assembly harness connector.
  3. Check continuity between BCM harness connector and ground.  

Is the inspection result normal?

YES >> Replace BCM. Refer to BCS "Removal and Installation".

NO >> Repair or replace harness.

3.CHECK TRUNK LID OPENER ACTUATOR GROUND CIRCUIT

Check continuity between trunk lid lock assembly harness connector and ground. 

Is the inspection normal?

YES >> Replace trunk lid lock assembly.

NO >> Repair or replace harness.

Shift P Warning lamp

Component Function Check 1.CHECK FUNCTION Select INTELLIGENT KEY of BCM using CONSULT. Select LCD in ACTIVE TEST mode. Touch SET P to check that it works normally. Is the inspection resu ...

Other materials:

P062F EEPROM
Description TCM checks the value read in FLASH ROM at ignition switch ON, and judges if there is writing failure to FLASH ROM or malfunction of FLASH ROM. DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P062F Inter ...

Transmitter
Exploded View 1. Transmitter (tire pressure sensor) 2. O-ring 3. Valve stem nut 4. Valve core 5. Valve cap 6. Valve stem assembly : Parts that are replaced as a set when the tire is replaced. Removal and Installation REMOVAL Remove road wheel and tire assembly using power tool. Refe ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.007