Nissan Versa (N17): U0155 Lost communication (IPC)

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / U0155 Lost communication (IPC)

DTC Logic

DTC DETECTION LOGIC

DTC Trouble diagnosis name DTC detection condition Possible causes
U0155 Lost Communication With Instrument Panel Cluster (IPC) Control Module When the ignition switch is ON, TCM is unable to receive the CAN communications signal from the combination meter continuously for 2 seconds or more.
  • Combination meter
  • Harness or connector (CAN communication line is open or shorted)

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

  1. Start engine and wait for at least 5 seconds.
  2. Check the DTC.

Is "U0155" detected?

YES >> Go to TM, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

For the diagnosis procedure, refer to LAN, "Trouble Diagnosis Flow Chart".

U0140 Lost communication (BCM)

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes U0140 Lost Communication With Body Control Module When the ignition ...

U0300 Can communication data

Description The amount of data transmitted from each control unit is read. DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes ...

Other materials:

Stall test
Work Procedure INSPECTION Inspect the amount of engine oil. Replenish the engine oil if necessary. Refer to LU "Inspection". Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is 50 to 80C (122 to 176F). Inspect the amount of ATF. Replenish ...

Both doors mirror defogger don't operate but rear window defogger operates
Diagnosis Procedure 1. CHECK DOOR MIRROR DEFOGGER FUSE Check if the following fuse in fuse block (J/B) is blown. Is the inspection result normal? YES >> GO TO 2 NO >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse. 2. CHECK BOTH DOOR MIRR ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0058