Nissan Versa

 Sedan Service Manual

Driver information & multimedia » Meter, warning lamp & indicator (MWI)
U1000 CAN Comm circuit

DTC Logic

DTC DETECTION LOGIC   

Diagnosis Procedure

1.CHECK DTC DETECTION

With CONSULT.

1. Turn ignition switch OFF to ON.

2. Perform self diagnostic result.

Is DTC U1000 detected?

YES >> Proceed to diagnosis procedure. Refer to LAN "Trouble Diagnosis Flow Chart".

NO >> Refer to GI "Intermittent Incident".

U1010 CONTROL UNIT (CAN)

Description

Initial diagnosis of combination meter.

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure

1.REPLACE COMBINATION METER

Replace combination meter. Refer to MWI"Removal and Installation".

>> Inspection End.

Precautions

System

Diagnosis system (combination meter)

Diagnosis and repair workflow

U1000 CAN Comm circuit

DTC B2205 Vehicle speed circuit

B2267 Engine speed

Power supply and ground circuit

Fuel level sensor signal circuit

Washer fluid level switch circuit

The fuel gauge indicator does not operate

The oil pressure warning lamp does not turn on

The low washer fluid warning continues displaying, or does not display

Combination meter

Combination meter

Precautions

System

Diagnosis system (combination meter)

Diagnosis and repair workflow

U1000 CAN Comm circuit

DTC B2205 Vehicle speed circuit

B2267 Engine speed

Power supply and ground circuit

Fuel level sensor signal circuit

Washer fluid level switch circuit

The fuel gauge indicator does not operate

The oil pressure warning lamp does not turn on

The low washer fluid warning continues displaying, or does not display

Combination meter

Combination meter