Nissan Versa (N17): ABS Warning lamp

Component Function Check

1.CHECK ABS WARNING LAMP FUNCTION

Check that ABS warning lamp in combination meter turns ON for approximately 2 seconds after ignition switch is turned ON.

Is the inspection result normal?

YES >> Inspection End.

NO >> Proceed to diagnosis procedure. Refer to BRC "Diagnosis Procedure".

Diagnosis Procedure

1.PERFORM THE SELF-DIAGNOSIS

With CONSULT.

Perform self diagnostic result.

Are any DTCs detected?

YES >> Refer to BRC "DTC Index".

NO >> GO TO 2.

2.CHECK COMBINATION METER

Check if indication and operation of combination meter are normal. Refer to MWI "METER SYSTEM : System Description" (type A) and MWI "METER SYSTEM : System Description" (type B).

Is the inspection result normal?

YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC "Removal and Installation".

NO >> Replace combination meter. Refer to MWI "Removal and Installation" (type A) or MWI "Removal and Installation" (type B).

VDC OFF Switch

Component Function Check 1.CHECK VDC OFF SWITCH OPERATION Check that VDC OFF indicator lamp in combination meter turns ON/OFF when VDC OFF switch is operated. Is the inspection result normal? ...

Other materials:

Kicking plate inner
KICKING PLATE INNER : Removal and Installation FRONT KICKING PLATE Removal     1.   Release front kicking plate pawls using a suitable tool (A) and remove front kicking plate as shown. CAUTION: Apply protective tape (B) to the body as shown before releasing the pawl ...

Hood lock control cable
HOOD LOCK CONTROL CABLE : Removal and Installation REMOVAL Disconnect hood lock control cable assembly from hood lock assembly. Refer to DLK "HOOD LOCK : Removal and Installation". Remove fender protector (LH). Refer to EXT "Removal and Installation". Release hoo ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0149