Nissan Versa (N17): Inspection and adjustment

Nissan Versa 2nd generation (N17) Service Manual / Restraints / SRS Airbag control system (SRC) / Inspection and adjustment

Additional service when replacing control unit

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description

Always perform zero point reset using CONSULT when removing and installing the passenger seat or servicing the occupant classification system.

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement

WORK PROCEDURE WHEN REPLACING OCS CONTROL UNIT

1.PERFORM ZERO POINT RESET

Perform zero point reset. Refer to SRC "ZERO POINT RESET : Special Repair Requirement".

>> END

Zero point reset

ZERO POINT RESET : Description

Zero point reset is an initializing procedure for the OCS (weight) sensors that must be performed using CONSULT when removing and installing passenger seat or servicing the OCS system. If zero point reset is not performed, the initialization is incomplete and OCS may not operate normally.

NOTE:

When reinstalling the passenger seat, the initial value for the OCS sensors may change, and the OCS may not operate normally.
When zero point reset is performed after removal and installation of passenger seat, CONSULT displays ""complete"".

ZERO POINT RESET : Special Repair Requirement

1.PERFORM ZERO POINT RESET

1. Perform preliminary checks:

NOTE:

Level the vehicle
Minimize vibrations near the vehicle
Remove any objects on passenger seat
Do not touch the vehicle during zero point reset

Select START on ZERO POINT RESET from, WORK SUPPORT of "OCCUPANT DETECTION".
"Zero point reset" starts.

>> GO TO 2.

2.CONFIRM RESET

1. Check that ""Complete" is displayed on "Zero point reset status".

CAUTION:

"Complete" may be displayed if the seat has been reinstalled, or "zero point reset" has already been performed.
"Incomplete" may be displayed if a new seat is installed.
Air bag warning lamp blinks in user mode if zero point reset is "incomplete".

Is zero point reset status "complete"?

YES >> Print out "ZERO POINT RESET CURRENT STATUS" screen. Inspection end.

NO >> Recheck the preliminary check items and perform zero point reset again.

INTERMITTENT INCIDENT

Inspection Procedure

INTERMITTENT TROUBLE

An intermittent incident may have occurred in the past but is not being detected currently. This DTC will not be detected on SELF-DIAG [CURRENT], but may be viewed on SELF-DIAG [PAST] if the DTC has not been erased.

Trouble Diagnosis with CONSULT

CHECK SRS REPAIR HISTORY

Refer to SRC "SRS History Check".

DTC/CIRCUIT DIAGNOSIS

Diagnosis and repair work flow

Work Flow OVERALL SEQUENCE *1 SRC "Diagnosis Description" *2 SRC "SRS Operation Check" *3 SRC "Trouble Diagnosis with CONSULT" *4 SRC "Trouble Diagnosis wi ...

B1049 - B1052, B1054 - B1057 Driver airbag module

Description DTC B1049 - B1052, B1054 - B1057 DRIVER AIRBAG MODULE The driver air bag module is dual stage and wired to the air bag diagnosis sensor unit through the spiral cable. The air bag d ...

Other materials:

P0744 Torque converter
Description This DTC is detected when the torque converter clutch solenoid valve is electrically normal but the torque converter clutch does not engage. This is not due to an electrical malfunction (circuit open or shorted), but is instead due to a mechanical malfunction (sticking of the cont ...