AIR CLEANER FILTER : Exploded View

1. Clamp 2. PCV hose 3. Clamp 4. Mount rubber 5. Air duct (inlet) 6. Air cleaner body 7. Grommet 8. Air cleaner filter 9. Air cleaner cover 10. Mass air flow sensor 11. Air duct 12. Clamp A. To electric throttle control actuator B. To rocker cover
AIR CLEANER FILTER : Removal and Installation
REMOVAL
1. Unhook clips (A) and pull the air cleaner cover upward (1).

2. Remove the air cleaner filter (1) from the air cleaner body.

INSTALLATION
Installation is in the reverse order of removal.
NOTE: Check that the air cleaner filter is securely placed in the air cleaner body.
Fuel linesFUEL LINES : Inspection Inspect fuel lines, fuel filler cap, and fuel tank for improper attachment, leakage, cracks, damage, loose connections, chafing or deterioration. (A) : Engine (B) : Fue ...

ENGINE OIL : Inspection ENGINE OIL LEVEL 1. Park vehicle on a level surface, wait 10 minutes before checking the engine oil level. 2. Pull out oil level gauge and wipe it clean. 3. Insert oil le ...
P0890 TCM
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0890
Transmission Control Module
Power Relay Sense Circuit Low
Under the following diagnosis
conditions, the battery voltage
supplied to the TCM is less than
...
Shift P Warning lamp
Component Function Check
1.CHECK FUNCTION
Select INTELLIGENT KEY of BCM using CONSULT.
Select LCD in ACTIVE TEST mode.
Touch SET P to check that it works normally.
Is the inspection result normal?
YES >> Shift P warning lamp is OK.
NO >> Refer to DLK "Diagnosis Proce ...