Nissan Versa (N17): Engine oil

ENGINE OIL : Inspection

ENGINE OIL LEVEL

1. Park vehicle on a level surface, wait 10 minutes before checking the engine oil level.

2. Pull out oil level gauge and wipe it clean.

3. Insert oil level gauge and make sure the engine oil level is within the range (A) as shown.

4. If it is out of range, adjust it.

ENGINE OIL LEVEL

ENGINE OIL : Draining

WARNING:

  • Be careful not to get burned, as engine oil may be hot.
  • Prolonged and repeated contact with used engine oil may cause skin cancer. Try to avoid direct skin contact with used engine oil. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible.

1. Warm up the engine, park the vehicle on a level surface and check for engine oil leaks. Refer to MA "ENGINE OIL : Inspection".

2. Stop the engine and wait for 10 minutes.

3. Loosen oil filler cap.

4. Remove drain plug and then drain engine oil.

ENGINE OIL : Refilling

1. Install drain plug with new copper sealing washer. Refer to EM "Exploded View".

CAUTION:

  • Be sure to clean drain plug and install new copper sealing washer.
  • Do not reuse copper sealing washer.

2. Refill with new engine oil.

Engine oil capacity and viscosity : Refer to MA "Fluids and Lubricants".

CAUTION:

  • The refill capacity depends on the engine oil temperature and drain time. Use these specifications for reference only.
  • Always use oil level gauge to determine the proper amount of engine oil in the engine.

3. Warm up engine and check area around drain plug and oil filter for engine oil leaks. Repair as necessary.

4. Stop engine and wait for 10 minutes.

5. Check the engine oil level. Refer to MA "ENGINE OIL : Inspection".

Air cleaner filter

AIR CLEANER FILTER : Exploded View 1. Clamp 2. PCV hose 3. Clamp 4. Mount rubber 5. Air duct (inlet) 6. Air cleaner body 7. Grommet 8. Air cleaner filter 9. Air cleaner cover 10. Mass air flow ...

Oil filter

OIL FILTER : Removal and Installation REMOVAL 1. Remove engine under cover. Refer to EXT "Removal and Installation". 2. Drain engine oil. Refer to MA "ENGINE OIL : Draining". 3 ...

Other materials:

Input shaft and gear
Exploded View 1. Input shaft front bearing 2. Input shaft 3. Snap ring 4. Input shaft rear bearing 5. Adapter plate 6. Bushing 7. 5th input gear 8. 5th-reverse baulk ring 9. Synchronizer lever 10. 5th-reverse synchronizer hub 11. 5th-reverse coupling sleeve 12. Lock washer 13. Retaining pi ...

P0712 Transmission fluid temperature sensor A
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0712 Transmission Fluid Temperature Sensor A Circuit Low The CVT fluid temperature identified by the TCM is 180C (356F) or more continuously for 5 seconds or ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0091