BACK-UP LAMP SWITCH : Component Inspection
1.CHECK BACK-UP LAMP SWITCH

Is the inspection result normal?
YES >> INSPECTION END
NO >> Replace position switch. Refer to TM, "Removal and Installation".

PARK/NEUTRAL POSITION (PNP) SWITCH : Component Inspection
1.CHECK PARK/NEUTRAL POSITION (PNP) SWITCH

Is the inspection result normal?
YES >> INSPECTION END
NO >> Replace position switch. Refer to TM, "Removal and Installation".

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary, repair or replace these parts.

Structure and operationSectional View 1. Clutch housing 2. 1st-2nd synchronizer hub assembly 3. 3rd-4th synchronizer hub assembly 4. 5th input gear 5. 5th-reverse synchronizer hub assembly 6. 5th-reverse baulk ri ...

Inspection OIL LEAKAGE Make sure that gear oil is not leaking from transaxle or around it. OIL LEVEL Remove filler plug (1) and gasket from transaxle case. Check the oil level from filler pl ...
System (power door lock system)
System Diagram
System Description
DOOR LOCK FUNCTION
The door lock and unlock switch (driver side) is built into power window
main switch.
The door lock and unlock switch (passenger side) is on door trim.
Interlocked with the locking operation of door lock and unlock swit ...
U1000 CAN Comm circuit
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK DTC DETECTION
With CONSULT.
1. Turn ignition switch OFF to ON.
2. Perform ...