Nissan Versa (N17): Both side front fog lamps are not turned on

Nissan Versa 2nd generation (N17) Service Manual / Driver controls / Exterior lighting system (EXL) / Both side front fog lamps are not turned on

Description

The front fog lamps do not turn ON in any setting.

Diagnosis Procedure

1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION

Check the combination switch (lighting and turn signal switch). Refer to BCS "Symptom Table" (with Intelligent Key) or BCS "Symptom Table" (without Intelligent Key).

Is the combination switch (lighting and turn signal switch) normal?

YES >> GO TO 2.

NO >> Repair or replace the malfunctioning part.

2.CHECK FRONT FOG LAMP REQUEST SIGNAL INPUT

CONSULT DATA MONITOR

  1. Select FR FOG REQ of IPDM E/R DATA MONITOR item.
  2. With operating the front fog lamp switch, check the monitor status.

Is the item status normal?

YES >> GO TO 3.

NO >> Replace BCM. Refer to BCS"Removal and Installation" (with Intelligent Key) or BCS "Removal and Installation" (without Intelligent Key).

3.FRONT FOG LAMP CIRCUIT INSPECTION

Check the front fog lamp circuit. Refer to EXL "Diagnosis Procedure".

Is the front fog lamp circuit normal?

YES >> Replace IPDM E/R. Refer to PCS "Removal and Installation" (with Intelligent Key) or PCS "Removal and Installation" (without Intelligent Key).

NO >> Repair or replace the malfunctioning part.

PERIODIC MAINTENANCE

Parking, license plate and tail lamps are not turned on

Description The parking, license plate and tail lamps do not turn ON in any combination switch (lighting and turn signal switch) position. Diagnosis Procedure 1.COMBINATION SWITCH (LIGHTING AND ...

Other materials:

Pedal vibration or ABS operation sound occurs
Diagnosis Procedure CAUTION: Under the following conditions, ABS is activated and vibration is felt when brake pedal is lightly depressed (just place a foot on it). However, this is normal. When shifting gears When driving on slippery road During cornering at high speed When passing o ...

Intelligent key battery
Removal and Installation 1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key. 2. Insert a suitable tool (A) wrapped with a cloth into the slit of the corner and twist it to separate the upper part from the lower part. CAUTION: Do not touch the circuit ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0056