Nissan Versa (N17): Trunk lid opener switch

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Trunk lid opener switch

Component Function Check

1.CHECK FUNCTION

  1. Select TRUNK of BCM using CONSULT.
  2. Select TR/BD OPEN SW in DATA MONITOR mode.
  3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?

YES >> Trunk lid switch is OK.

NO >> Refer to DLK "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to DLK "TRUNK LID OPENER SYSTEM : Wiring Diagram".

1.CHECK TRUNK LID OPENER INPUT SIGNAL

  1. Turn ignition switch OFF.
  2. Disconnect trunk lid switch connector.
  3. Check signal between trunk lid switch harness connector and ground using oscilloscope. 

Is the inspection result normal?

YES >> GO TO 3.

NO >> GO TO 2.

2.CHECK TRUNK LID OPENER SWITCH CIRCUIT

  1. Disconnect BCM connector.
  2. Check continuity between BCM harness connector and trunk lid switch harness connector. 
  3. Check continuity between BCM harness connector and ground. 

Is the inspection result normal?

YES >> Replace BCM. Refer to BCS "Removal and Installation".

NO >> Repair or replace harness.

3.CHECK TRUNK LID SWITCH GROUND CIRCUIT

Check continuity between trunk lid switch harness connector and ground. 

Is the inspection result normal?

YES >> GO TO 4.

NO >> Repair or replace harness.

4.CHECK TRUNK LID SWITCH

Refer to DLK "Component Function Check".

Is the inspection result normal?

YES >> GO TO 5.

NO >> Replace trunk lid switch.

5.CHECK INTERMITTENT INCIDENT

Refer to GI "Intermittent Incident".

>> Inspection End.

Component Inspection

1.CHECK TRUNK LID SWITCH

  1. Turn ignition switch OFF.
  2. Disconnect trunk lid switch connector.
  3. Check continuity between trunk lid switch terminals.

Is the inspection result normal?

YES >> Inspection End.

NO >> Replace trunk lid switch.

Trunk lid opener actuator

Component Function Check 1.CHECK FUNCTION Select INTELLIGENT KEY of BCM using CONSULT. Select TRUNK/GLASS HATCH in ACTIVE TEST mode. Touch OPEN to check that it works normally. Is the insp ...

Trunk lamp switch

Description Detects trunk open/close condition. Component Function Check 1.CHECK FUNCTION With CONSULT Check TRNK/HAT MNTR in Data Monitor mode with CONSULT.   Is the inspection ...

Other materials:

Basic inspection
Work Procedure 1.INSPECTION START     1.   Check service records for any recent repairs that may indicate a related malfunction, or a current need for scheduled maintenance.     2.   Open engine hood and check the following: Harness con ...

Clutch pedal
Exploded View 1. Clutch pedal 2. Pedal stopper rubber 3. Pedal pad 4. Clip 5. Clutch interlock switch Removal and Installation REMOVAL Remove the instrument lower panel LH. Refer to IP, "Removal and Installation". Disconnect master cylinder rod end from clutch pedal. D ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0062