Nissan Versa (N17): Front wiper motor hi circuit

Nissan Versa 2nd generation (N17) Service Manual / Driver controls / Wiper & washer (WW) / Front wiper motor hi circuit

Component Function Check

1.CHECK FRONT WIPER HI OPERATION

IPDM E/R AUTO ACTIVE TEST

1. Start IPDM E/R auto active test. Refer to PCS "Diagnosis Description" or PCS "Diagnosis Description".

2. Check that the front wiper operates on HI operation.

CONSULT ACTIVE TEST

1. Select FR WIPER of BCM (WIPER) active test item.

2. Check front wiper operation.

HI : Front wiper (HI) operation

OFF : Front wiper OFF

Is the inspection result normal?

YES >> Front wiper motor HI circuit is normal.

NO >> Refer to WW "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to WW "Wiring Diagram".

1. CHECK FRONT WIPER MOTOR FUSE

1. Turn the ignition switch OFF.

2. Check that the following fuse is not blown.

Is the fuse blown?

YES >> Replace the fuse after repairing the affected circuit.

NO >> GO TO 2

2. CHECK FRONT WIPER MOTOR (HI) OUTPUT VOLTAGE

1. Turn the ignition switch ON.

2. Select FR WIPER of BCM (WIPER) active test item.

3. While performing the active test, check voltage between IPDM E/R harness connector and ground.

Is the inspection result normal?

YES >> GO TO 3

NO >> Replace IPDM E/R. Refer to PCS "Removal and Installation".

3. CHECK FRONT WIPER MOTOR (HI) OPEN CIRCUIT

1. Turn the ignition switch OFF.

2. Disconnect IPDM E/R and front wiper motor.

3. Check continuity between IPDM E/R harness connector and front wiper motor harness connector.

Is the inspection result normal?

YES >> Replace front wiper motor. Refer to WW "WIPER DRIVE ASSEMBLY : Removal and Installation".

NO >> Repair or replace harness.

Other materials:

Basic inspection
Work Procedure 1.INSPECTION START     1.   Check service records for any recent repairs that may indicate a related malfunction, or a current need for scheduled maintenance.     2.   Open engine hood and check the following: Harness con ...

Line pressure test
Work Procedure INSPECTION Check the engine oil level. Replenish if necessary. Refer to LU "Inspection". Check for CVT fluid leaks. Refer to TM "Inspection". Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80C (122 to ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0103