COMBINATION METER SELF-DIAGNOSIS MODE
The information display, speedometer and tachometer can be checked in self-diagnosis mode.
STARTING COMBINATION METER SELF-DIAGNOSIS MODE
NOTE:
How to Initiate Self-Diagnosis Mode
1. Turn ignition switch ON, press the odo/trip meter switch (1) to "trip A" or "trip B".
2. Turn ignition switch to OFF.
3. Continue holding the odo/trip meter switch (1) and turn the ignition switch ON.
4. Verify the trip meter displays "0000.0".
5. Press the meter control switch at least 3 times. (Within 7 seconds after the ignition switch is turned ON).
6. The combination meter self-diagnosis mode is activated.
- Verify all segments of the information display and shift position indicator (A) for CVT models are displayed.
7. Each meter activates by pressing the meter control switch.
NOTE:
APPLICATION ITEMS
CONSULT can display each diagnostic item using the diagnostic test modes
shown.
SELF DIAG RESULT
Refer to MWI "DTC Index".
DATA MONITOR
Display Item List
NOTE: Some items are not available according to vehicle specification.
SPECIAL FUNCTION
Special menu
W/L ON HISTORY
- 0: The condition that the warning/indicator lamp has been turned on 1 or more times after starting the engine and waiting for 30 seconds.
- 1 - 39: The number of times the engine was restarted after the 0 condition.
- NO W/L ON HISTORY: Stores NO (0) turning on history of warning/indicator lamp.
NOTE:
Display Item
ECU DIAGNOSIS INFORMATION
COMBINATION METER
Reference Value
VALUES ON THE DIAGNOSIS TOOL
*: Displays "Off" if the brake warning lamp is illuminated when the valve check starts, the parking brake switch is turned ON or the brake fluid level switch is turned ON.
NOTE: Some items are not available according to vehicle specification.
TERMINAL LAYOUT
PHYSICAL VALUES
Fail-Safe
The combination meter activates the fail-safe control if CAN communication with each unit is malfunctioning.
DTC Index
BCM (BODY CONTROL MODULE)
List of ECU Reference
ECU | Reference |
BCM (with Intelligent Key) | BCS "Reference Value" |
BCS "Wiring Diagram" | |
BCS"Fail-safe" | |
BCS"DTC Inspection Priority Chart" | |
BCS"DTC Index" | |
BCM (without Intelligent Key) | BCS "Reference Value" |
BCS "Wiring Diagram" | |
BCS "Fail-safe" | |
BCS "DTC Inspection Priority Chart" | |
BCS"DTC Index" |
WIRING DIAGRAM
METER SYSTEM
Wiring Diagram
BASIC INSPECTION
Work Flow OVERALL SEQUENCE DETAILED FLOW 1.CONFIRM SYMPTOM Confirm symptom or customer complaint. >> GO TO 2 2.SELF-DIAGNOSIS OF COMBINATION METER Perform self-diagnosis of combinat ...
U0300 Can communication data
Description
The amount of data transmitted from each control unit is read.
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
U0300
Internal Control Module Software
Incompatibility
When the amount of data transmitt ...
Performance test
Inspection
INSPECTION PROCEDURE
Connect recovery/recycling/recharging equipment (for HFC-134a) or
manifold gauge.
Start the engine, and set to the following condition.
Test condition &n ...