Nissan Versa (N17): Trunk lid opener switch

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Trunk lid opener switch

Component Function Check

1.CHECK FUNCTION

  1. Select TRUNK of BCM using CONSULT.
  2. Select TR/BD OPEN SW in DATA MONITOR mode.
  3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?

YES >> Trunk lid switch is OK.

NO >> Refer to DLK "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to DLK "TRUNK LID OPENER SYSTEM : Wiring Diagram".

1.CHECK TRUNK LID OPENER INPUT SIGNAL

  1. Turn ignition switch OFF.
  2. Disconnect trunk lid switch connector.
  3. Check signal between trunk lid switch harness connector and ground using oscilloscope. 

Is the inspection result normal?

YES >> GO TO 3.

NO >> GO TO 2.

2.CHECK TRUNK LID OPENER SWITCH CIRCUIT

  1. Disconnect BCM connector.
  2. Check continuity between BCM harness connector and trunk lid switch harness connector. 
  3. Check continuity between BCM harness connector and ground. 

Is the inspection result normal?

YES >> Replace BCM. Refer to BCS "Removal and Installation".

NO >> Repair or replace harness.

3.CHECK TRUNK LID SWITCH GROUND CIRCUIT

Check continuity between trunk lid switch harness connector and ground. 

Is the inspection result normal?

YES >> GO TO 4.

NO >> Repair or replace harness.

4.CHECK TRUNK LID SWITCH

Refer to DLK "Component Function Check".

Is the inspection result normal?

YES >> GO TO 5.

NO >> Replace trunk lid switch.

5.CHECK INTERMITTENT INCIDENT

Refer to GI "Intermittent Incident".

>> Inspection End.

Component Inspection

1.CHECK TRUNK LID SWITCH

  1. Turn ignition switch OFF.
  2. Disconnect trunk lid switch connector.
  3. Check continuity between trunk lid switch terminals.

Is the inspection result normal?

YES >> Inspection End.

NO >> Replace trunk lid switch.

Trunk lid opener actuator

Component Function Check 1.CHECK FUNCTION Select INTELLIGENT KEY of BCM using CONSULT. Select TRUNK/GLASS HATCH in ACTIVE TEST mode. Touch OPEN to check that it works normally. Is the insp ...

Trunk lamp switch

Description Detects trunk open/close condition. Component Function Check 1.CHECK FUNCTION With CONSULT Check TRNK/HAT MNTR in Data Monitor mode with CONSULT.   Is the inspection ...

Other materials:

EPS System
EPS SYSTEM : System Description EPS control unit performs an arithmetical operation on data, such as steering wheel turning force (sensor signal) from the torque sensor, vehicle speed signal, etc. Then it generates an optimum assist torque signal to the EPS motor according to the drivi ...

Low-pressure flexible hose
Removal and Installation CAUTION: Perform oil return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or oil is detected, do not perform oil return operation. Refer to HA "Perform Oil Return Operation". REMOVAL Use refrigerant ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0059