Nissan Versa

 Sedan Service Manual

Body interior » Seat (SE) » Rear seat
Disassembly and Assembly - Fixed Seatback

FIXED SEATBACK

1. Seatback pad 2. Seatback trim A. Hog rings

Disassembly

1. Remove the rear seatback assembly. Refer to SE "Removal and Installation - Fixed Seatback".
2. Release locks as shown and remove the headrest holders.

CAUTION: Before removing/installing the headrest holder, check its orientation (front/rear and right/left)

    3.   Remove the hog rings from the back side of the rear seatback assembly.

    4.   Remove the hog rings from the front side of the rear seatback assembly and separate the seatback trim from the seatback pad.

NOTE: Remove all pieces of hog rings and discard them.

Assembly

Assembly is in the reverse order of disassembly.

CAUTION:

• Make sure hog rings are correctly fastened around both the seatback trim and seatback pad wires.
• Replace any deformed or damaged hog rings.
• Make sure any old hog ring pieces are removed from seat.

NOTE:

• Install new hog rings on the seatback trim in original positions.
• Use only one hog ring in each designated location.

Disassembly and Assembly - Seat Cushion

Disassembly and Assembly - Fixed Seatback

Disassembly and Assembly - Split Seatback