Removal and Installation
REMOVAL
1. Remove the instrument lower panel LH (1). Refer to IP "Removal and Installation".

2. Remove door mirror remote control switch (1) from the instrument lower panel LH using a suitable tool.
: Pawl

INSTALLATION
Installation is in the reverse order of removal.
Door mirror rear finisherRemoval and Installation REMOVAL 1. Remove the door mirror glass. Refer to MIR "Removal and Installation". 2. Apply protective tape on mirror body (A). Disengage the pawls and remove d ...
Additional service when replacing
ECM
Description
When replacing ECM, the following procedure must be performed.
PROGRAMMING OPERATION
NOTE:
After replacing with a blank ECM, programming is required to write ECM
information. Be sure to follow the procedure
to perform the programming.
Work Procedure
1.CHECK ECM PART NUMBER
Che ...
P0973 Shift solenoid A
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0973
Shift Solenoid "A" Control Circuit
Low
The following diagnosis conditions
are met, and the TCM select
switch ON-OFF solenoid
valve monitor value is ON c ...