Nissan Versa (N17): Door switch

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Door switch

Exploded View

Exploded View

1. Door switch 2. Door switch bolt

Removal and Installation

REMOVAL

1. Remove the door switch bolt (A).

2. Disconnect the harness connector from door switch (1) and remove.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Fuel filler lid lock

FUEL FILLER LID LOCK : Removal and Installation REMOVAL 1. Fully open fuel filler lid. 2. Remove trunk side finisher (LH). Refer to INT "TRUNK SIDE FINISHER : Removal and Installation". ...

Remote keyless entry receiver

Removal and Installation REMOVAL 1. Remove the glove box. Refer to IP "Removal and Installation". 2. Remove the remote keyless entry receiver bolt (A). 3. Disconnect the harness connec ...

Other materials:

Camshaft valve clearance
Inspection and Adjustment INSPECTION Perform inspection as follows after removal, replacement or installation of camshaft or valverelated parts, or if there are unusual engine conditions regarding valve clearance. Remove rocker cover. Measure the valve clearance with the following proced ...

Oil cooler
Exploded View 1. Radiator hose (upper) 2. Hose clamp 3. Radiator hose (lower) 4. Hose clamp 5. Water hose 6. Oil cooler 7. Connector bolt 8. Water hose 9. Oring A. To radiator (upper side) B. To radiator (lower side) 10. Relief valve Removal and Installation REMOVAL NOTE: When removing co ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0075