Nissan Versa (N17): C1111 Pump motor

DTC Logic

DTC DETECTION LOGIC               

DTC CONFIRMATION PROCEDURE

1.CHECK SELF DIAGNOSTIC RESULT

With CONSULT.

  1. Turn ignition switch OFF.
  2. Depress brake pedal 20 times or more.
  3. Start the engine and wait for 3 minutes or more.
  4. Perform self diagnostic result.

Is DTC C1111 detected?

YES >> Proceed to diagnosis procedure. Refer to BRC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to BRC "Wiring Diagram".

1.CONNECTOR INSPECTION

  1. Turn ignition switch OFF.
  2. Disconnect ABS actuator and electric unit (control unit) connectors.
  3. Check connectors and terminals for deformation, disconnection, looseness or damage.

Is the inspection result normal?

YES >> GO TO 2

NO >> Repair or replace as necessary.

2.CHECK ABS MOTOR AND MOTOR RELAY BATTERY POWER SUPPLY

Check voltage between ABS actuator and electric unit (control unit) connector E33 terminal 1 and ground.

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace malfunctioning components.

3.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) GROUND CIRCUIT

Check continuity between ABS actuator and electric unit (control unit) connector E33 terminals 13, 38 and ground.           

Is the inspection result normal?

YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC "Removal and Installation".

NO >> Repair or replace malfunctioning components.

C1110, C1153, C1170 ABS Actuator and electric unit (control unit)

DTC Logic DTC DETECTION LOGIC    DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSIS RESULTS Check the self-diagnosis results.          ...

Other materials:

Windshield-washer fluid
Windshield-washer fluid reservoir Add a washer solvent to the windshield-washer fluid reservoir for better cleaning. In the winter season, add a windshield-washer antifreeze. Follow the manufacturer's instructions for the mixture ratio. Refill the reservoir more frequently when driving ...

Side oil seal
Removal and Installation REMOVAL Remove front drive shaft from transaxle assembly. Refer to FAX, "Removal and Installation". Remove differential side oil seal (1) using suitable tool. CAUTION: Do not damage transaxle case and clutch housing. INSTALLATION   & ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0072