Nissan Versa (N17): Low tire pressure warning lamp

Nissan Versa 2nd generation (N17) Service Manual / Suspension / Road wheels & tires (WT) / Low tire pressure warning lamp

Component Function Check

1.CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP

Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is turned ON.

Is the inspection result normal?

YES >> Inspection End.

NO >> Perform trouble diagnosis. Refer to WT "Diagnosis Procedure".

Diagnosis Procedure

1.PERFORM SELF DIAGNOSTIC RESULT

With CONSULT

  1. Turn the ignition switch ON.
  2. Perform "SELF DIAGNOSTIC RESULT".

Are any DTCs detected?

YES >> Refer to BCS "DTC Index" or BCS "DTC Index".

NO >> GO TO 3.

2.CHECK LOW TIRE PRESSURE WARNING LAMP SIGNAL

With CONSULT

  1. Turn the ignition switch ON.
  2. On "DATA MONITOR" select "WARNING LAMP."
  3. Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is turned ON.

Is the inspection result normal?

YES >> Check the combination meter. Refer to MWI, "CONSULT Function" (type B) or MWI "CONSULT Function" (type A).

NO >> Replace the BCM. Refer to BCS "Removal and Installation" or BCS "Removal and Installation".

Other materials:

P1715 Input speed sensor
Description ECM receives input speed sensor signal from TCM via the CAN communication line. ECM uses this signal for engine control. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P1715 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX. If DTC P1715 is displa ...

Stall test
Work Procedure INSPECTION Inspect the amount of engine oil. Replenish the engine oil if necessary. Refer to LU "Inspection". Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is 50 to 80C (122 to 176F). Inspect the amount of ATF. Replenish ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0097