Nissan Versa (N17): B2622 Inside antenna

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / B2622 Inside antenna

DTC Logic

DTC DETECTION LOGIC 

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Select INTELLIGENT KEY of BCM using CONSULT.
  2. Select INSIDE ANT DIAGNOSIS in WORK SUPPORT mode.
  3. Perform inside key antenna (INSIDE ANT DIAGNOSIS) on WORK SUPPORT of INTELLIGENT KEY.
  4. Check BCM for DTC.

Is inside key antenna DTC detected?

YES >> Refer to DLK "Diagnosis Procedure".

NO >> Inside key antenna (console) is OK.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to DLK "INTELLIGENT KEY SYSTEM : Wiring Diagram".

1.CHECK INSIDE KEY ANTENNA INPUT SIGNAL 1

  1. Turn ignition switch ON.
  2. Check signal between BCM harness connector and ground using oscilloscope.

Is the inspection result normal?

YES >> Replace BCM. Refer to BCS "Removal and Installation".

NO >> GO TO 2.

2.CHECK INSIDE KEY ANTENNA CIRCUIT

  1. Turn ignition switch OFF.
  2. Disconnect BCM connector and inside key antenna (console) connector.
  3. Check continuity between BCM harness connector and inside key antenna (console) harness connector
  4. Check continuity between BCM harness connector and ground. 

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace harness.

3.CHECK INSIDE KEY ANTENNA INPUT SIGNAL 2

  1. Replace inside key antenna (console). (New antenna or other antenna)
  2. Connect BCM connector and inside key antenna (console) connector.
  3. Turn ignition switch ON.
  4. Check signal between BCM harness connector and ground using oscilloscope. 

Is the inspection result normal?

YES >> Replace inside key antenna (console).

NO >> Replace BCM. Refer to BCS "Removal and Installation".

Other materials:

Line pressure test
Work Procedure INSPECTION Check the engine oil level. Replenish if necessary. Refer to LU "Inspection". Check for CVT fluid leaks. Refer to TM "Inspection". Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80C (122 to ...

P062F EEPROM
Description TCM compares the calculated value stored in the flash ROM with the value stored in TCM. If the calculated value does not agree with the stored value, TCM judges this as a malfunction. DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.007