Nissan Versa (N17): B2195 Anti-scanning

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / B2195 Anti-scanning

DTC Logic

DTC DETECTION LOGIC   

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC in Self Diagnostic Result mode of BCM using CONSULT.

Is DTC detected?

YES >> Refer to SEC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK SELF DIAGNOSTIC RESULT 1

1. Select Self Diagnostic Result mode of BCM using CONSULT.

2. Erase DTC.

3. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to SEC "DTC Logic".

Is DTC detected?

YES >> GO TO 2.

NO >> Inspection End.

2.CHECK EQUIPMENT OF THE VEHICLE

Check that unspecified accessory part related to engine start is not installed.

Is unspecified accessory part related to engine start installed?

YES >> GO TO 3.

NO >> GO TO 4.

3.CHECK SELF DIAGNOSTIC RESULT 2

1. Obtain the customers approval to remove unspecified accessory part related to engine start, and then remove it.

2. Select Self Diagnostic Result of BCM using CONSULT.

3. Erase DTC.

4. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to SEC "DTC Logic".

Is DTC detected?

YES >> GO TO 4.

NO >> Inspection End.

4.REPLACE BCM

1. Replace BCM. Refer to BCS "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

>> Inspection End.

B2196 Dongle unit

Description BCM performs ID verification between BCM and dongle unit. When verification result is OK, BCM permits cranking. ...

Other materials:

Air cleaner and air duct
Exploded View 1. Clamp 2. PCV hose 3. Clamp 4. Mount rubber 5. Air duct (inlet) 6. Air cleaner body 7. Grommet 8. Air cleaner filter 9. Air cleaner cover 10. Mass air flow sensor 11. Air duct 12. Clamp Removal and Installation REMOVAL NOTE: Mass air flow sensor is removable as an assemb ...

P074B Unable to engage 3GR
Description This malfunction is detected when the A/T does not shift into 3GR position as instructed by TCM. This is not only caused by electrical malfunction (circuits open or shorted) but by mechanical malfunction such as control valve sticking, improper solenoid valve operation, etc. DTC ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0067