Nissan Versa (N17): B26FC Key registration

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / B26FC Key registration

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

2. Check DTC in Self Diagnostic Result mode of BCM using CONSULT.

Is DTC detected?

YES >> Go to SEC "Diagnosis Procedure"

NO >> Inspection End.

Diagnosis Procedure

1.REPLACE INTELLIGENT KEY

1. Prepare Intelligent Key that matches the vehicle.

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

3. Check DTC in Self Diagnostic Result mode of BCM using CONSULT.

Is DTC detected?

YES >> GO TO 2.

NO >> Inspection End.

2.REPLACE BCM

1. Replace BCM. Refer to BCS "Removal and Installation".

2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

>> Inspection End.

Other materials:

Push-button ignition switch (if so equipped)
WARNING Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive times in quick succession or the ignition switch is pushed and held for more than 2 seconds.) If the engine stops ...

Compression pressure
Inspection Warm up engine and then turn it off. Release fuel pressure. Remove ignition coil and spark plug from each cylinder. Connect engine tachometer (not required in use of CONSULT). Install compression gauge (B) with an adapter (A) (commercial service tool) onto spark plug hole. ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.008