Nissan Versa (N17): B2616 Ignition relay circuit

DTC Logic

DTC DETECTION LOGIC               

DTC CONFIRMATION PROCEDURE

1. PERFORM SELF DIAGNOSTIC RESULT

1. Turn ignition switch ON under the following conditions, and wait for at least 1 second.

• CVT selector lever is in the P (park) or N (neutral) position.
• Release brake pedal

2. Perform self diagnostic result.

Is DTC B2616 detected?

YES >> Refer to PCS "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to PCS "Wiring Diagram".

1. CHECK IGNITION RELAY-2 POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BCM connector M98.

3. Check continuity between ignition relay-2 connector J-3 terminal 1 and BCM connector M98 terminal 99.

4. Check continuity between ignition relay-2 connector J-3 terminal 1 and ground.

Is the inspection result normal?

YES >> GO TO 2.

NO >> Repair or replace harness or connectors.

2. CHECK IGNITION RELAY-2 GROUND CIRCUIT

1. Check continuity between ignition relay-2 connector J-3 terminal 2 and ground.

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace harness or connectors.

3. CHECK IGNITION RELAY-2

Perform the relay component inspection. Refer to PCS "Component Inspection".

Is the inspection result normal?

YES >> GO TO 4.

NO >> Replace ignition relay-2.

4. CHECK IGNITION RELAY-2 POWER SUPPLY (BCM)

Check voltage between BCM connector M98 terminal 99 and ground.

Is the inspection result normal?

YES >> Refer to GI "Intermittent Incident".

NO >> Replace BCM. Refer to BCS "Removal and Installation".

Component Inspection

1.CHECK IGNITION RELAY

1. Turn ignition switch OFF.

2. Remove ignition relay.

3. Check the continuity between ignition relay terminals.                   

Is the inspection result normal?

YES >> Inspection End.

NO >> Replace ignition relay