NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
VALUES ON THE DIAGNOSIS TOOL



TERMINAL LAYOUT

PHYSICAL VALUES









FAIL-SAFE CONTROL BY DTC
BCM performs fail-safe control when any DTC are detected.
FAIL-SAFE CONTROL OF COMBINATION SWITCH READING FUNCTION CAUSED BY LOW POWER SUPPLY VOLTAGE
If voltage of battery power supply lower, BCM maintains combination switch reading to the status when input voltage is less than approximately 9 V.
NOTE: When voltage of battery power supply is approximately 9 V or more, combination switch reading function returns to normal operation.
DTC Inspection Priority Chart
If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart.

DTC Index
NOTE: Details of time display


WIRING DIAGRAM
BCM
Wiring Diagram




BASIC INSPECTION
Brake caliper assembly
BRAKE CALIPER ASSEMBLY : Exploded View
REMOVAL
1. Brake caliper assembly
DISASSEMBLY
1. Cap 2. Bleeder valve 3. Cylinder body
4. Piston seal 5. Piston 6. Piston boot
7. Sliding pin 8. Sliding pin boot 9. Bushing
10. Torque member Apply rubber
grease Apply brake fluid
NOTE:
LH front ...
Rear seat
Exploded View - Fixed Seatback
FIXED SEATBACK
1. Headrest holder (locked) 2. Headrest holder (free) 3. Rear seatback
assembly
4. Seatback trim 5. Seatback pad 6. LATCH bracket (RH)
7. Seat cushion assembly 8. Seat cushion trim 9. Seat cushion pad
10. Seat cushion hook 11. LATCH bracket (L ...