Diagnosis Procedure
Regarding Wiring Diagram information, refer to WW "Wiring Diagram".
1. CHECK FRONT WIPER MOTOR GROUND CIRCUIT
1. Turn the ignition switch OFF.
2. Disconnect front wiper motor.
3. Check continuity between front wiper motor harness connector and ground.
Is the inspection result normal?
YES >> Front wiper motor ground circuit is normal.
NO >> Repair or replace harness.

Diagnosis Procedure Regarding Wiring Diagram information, refer to WW "Wiring Diagram". 1. CHECK FRONT WASHER MOTOR FUSE 1. Turn the ignition switch OFF. 2. Check that the following fuse ...
Position switch
Removal and Installation
REMOVAL
Drain gear oil. Refer to TM, "Draining".
Disconnect the harness connector (A) from position switch.
Remove position switch from transaxle case.
INSTALLATION
Apply recommended sealant to threads of position switch.
&nbs ...
Door lock
DOOR LOCK : Removal and Installation
REMOVAL
Remove inside handle. Refer to DLK "INSIDE HANDLE : Removal and
Installation".
Remove outside handle. Refer to DLK "OUTSIDE HANDLE : Removal and
Installation".
Disconnect the harness connector from door lock actuator (if ...