Nissan Versa (N17): Hood lock control cable

HOOD LOCK CONTROL CABLE : Removal and Installation

REMOVAL

1. Disconnect hood lock control cable assembly from hood lock assembly. Refer to DLK "HOOD LOCK : Removal and Installation".
2. Remove fender protector (LH). Refer to EXT "Removal and Installation".
3. Release hood lock control cable clips.
4. Remove hood lock/fuel filler door release handle assembly bolts (A).
5. Disconnect hood lock control cable assembly from hood lock/ fuel filler door release handle assembly.

6. Remove dash side finisher (LH). Refer to INT "DASH SIDE FINISHER : Removal and Installation"
7. Remove grommet on the lower dash and pull the hood lock control cable into the passenger compartment.

CAUTION: While pulling, be careful not to damage (peel) the outside of the hood lock control cable.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

• Be careful not to bend cable too much, keep the radius 100 mm (3.94 in) or more.
• Check that cable is not offset from the positioning grommet, and apply the sealant to the grommet (at * mark).

• Check that hood lock control cable is properly engaged with hood lock.
• Perform hood adjustment procedure. Refer to DLK "HOOD ASSEMBLY : Adjustment".
• After installation, perform hood lock inspection. Refer to DLK "Inspection".