Nissan Versa (N17): Keyfob ID set up with consult

ID Code Entry Procedure

KEYFOB ID SET UP WITH CONSULT

NOTE:

• If a keyfob is lost, the ID code of the lost keyfob must be erased to prevent unauthorized use. A specific ID code can be erased with CONSULT. However, when the ID code of a lost keyfob is not known, all controller ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new keyfobs must be re-registered.
• When registering an additional keyfob, the existing ID codes in memory may or may not be erased. If five ID codes are stored in memory when an additional code is registered, only the oldest code is erased. If less than five codes are stored in memory when an additional code is registered, the new ID code is added and no ID codes are erased.
• Entry of a maximum of five ID codes is allowed. When more than five codes are entered, the oldest ID code will be erased.
• Even if the same ID code that is already in memory is input, the same ID code can be entered. The code is counted as an additional code.

1. Turn ignition switch ON.
2. Select BCM.
3. Select MULTI REMOTE ENT.
4. Select WORK SUPPORT.
5. You can register, erase or confirm a keyfob ID code. To register a new code, select the following option and follow CONSULT instructions:

• REMO CONT ID REGIST

Use this mode to register a keyfob ID code.

NOTE: Register the ID code when keyfob or BCM is replaced, or when additional keyfob is required.

• REMO CONT ID ERASUR

Use this mode to erase a keyfob ID code.

• REMO CONT ID CONFIR

Use this mode to confirm if a keyfob ID code is registered or not.