Nissan Versa (N17): None of the power windows can be operated using any switch

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Power window control system (PWC) / None of the power windows can be operated using any switch

Diagnosis Procedure

1.CHECK BCM POWER SUPPLY AND GROUND CIRCUIT

Check BCM power supply and ground circuit. Refer to PWC "BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) : Diagnosis Procedure" (with Intelligent Key system) or PWC "BCM (BODY CONTROL SYSTEM) (WITHOUT INTELLIGENT KEY SYSTEM) : Diagnosis Procedure" (without Intelligent Key system).

Is the inspection result normal?

YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CHECK POWER WINDOW MAIN SWITCH POWER SUPPLY AND GROUND CIRCUIT

Check power window main switch power supply and ground circuit.

Refer to PWC "POWER WINDOW MAIN SWITCH : Diagnosis Procedure".

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CONFIRM THE OPERATION

Confirm the operation again.

Is the result normal?

YES >> Check intermittent incident. Refer to GI "Intermittent Incident".

NO >> GO TO 1.

Door switch

Description Detects door open/close condition and transmits the signal to BCM. ...

Driver side power window does not operate

Diagnosis Procedure 1.CHECK FRONT POWER WINDOW MOTOR LH Check front power window motor LH. Refer to PWC "DRIVER SIDE : Component Function Check". Is the inspection result normal? YES ...

Other materials:

Camshaft valve clearance
Inspection and Adjustment INSPECTION Perform inspection as follows after removal, replacement or installation of camshaft or valverelated parts, or if there are unusual engine conditions regarding valve clearance. Remove rocker cover. Measure the valve clearance with the following proced ...

Slip indicator lamp
Component Function Check 1.CHECK SLIP INDICATOR LAMP FUNCTION Check that slip indicator lamp in combination meter turns ON for approximately 2 seconds after ignition switch is turned ON. Is the inspection result normal? YES >> Inspection End. NO >> Proceed to diagnosis procedure. ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.017