Nissan Versa (N17): O/D OFF indicator lamp

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / O/D OFF indicator lamp

Component Function Check

1.CHECK O/D OFF INDICATOR LAMP FUNCTION

Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON.

Is the inspection results normal?

YES >> INSPECTION END

NO >> Go to TM "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC (TCM)

With CONSULT

  1. Turn ignition switch ON.
  2. Check "Self Diagnostic Results" in "TRANSMISSION".

Is any DTC detected?

YES >> Check DTC detected item. Refer to TM "DTC Index".

NO >> GO TO 2.

2.CHECK DTC (COMBINATION METER)

With CONSULT

Check "Self Diagnostic Results" in "METER/M&A".

Is any DTC detected?

YES >> Check DTC detected item. Refer to MWI "DTC Index".

NO >> GO TO 3.

3.CHECK COMBINATION METER INPUT SIGNAL

With CONSULT

  1. Shift the selector lever to "D" position.
  2. Select "Data Monitor" in "METER/M&A".
  3. Select "O/D OFF IND".
  4. Check that "O/D OFF IND" turns ON/OFF when overdrive control switch is operated. Refer to MWI "Reference Value".

Is the inspection result normal?

YES >> Replace combination meter. Refer to MWI "Removal and Installation".

NO >> GO TO 4.

4.CHECK TCM INPUT/OUTPUT SIGNAL

With CONSULT

  1. Select "Data Monitor" in "TRANSMISSION".
  2. Select "OD CONT SW".
  3. Check that "OD CONT SW" turns ON/OFF when overdrive control switch is operated. Refer to TM-99, "Reference Value".

Is the inspection result normal?

YES >> Replace combination meter. Refer to MWI "Removal and Installation".

NO >> Check overdrive control switch. Refer to TM "Diagnosis Procedure".

Shift position indicator circuit

Component Parts Function Inspection 1.CHECK SHIFT POSITION INDICATOR Start the engine. Shift the selector lever. Check that the selector lever position and the shift position indicator o ...

Other materials:

Exhaust manifold
Exploded View 1. Exhaust manifold cover 2. Harness bracket 3. Airfuel ratio sensor 1 4. Exhaust manifold stay 5. Heat insulator 6. Exhaust manifold 7. Exhaust manifold cover 8. Gasket : Engine front Removal and Installation REMOVAL Remove air duct (inlet), air duct and air cleaner as ...

Clutch piping
Exploded View 1. CSC (Concentric Slave Cylinder) 2. Clutch tube 3. Clutch damper 4. Bracket 5. Master cylinder Hydraulic Layout 1. Clutch tube 2. Lock pin 3. CSC (concentric slave cylinder) 4. Clutch damper 5. Master cylinder 6. Clutch pedal Removal and Installation CAUTION: Do not ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0059