Nissan Versa (N17): Output speed sensor

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / Output speed sensor

Exploded View

Exploded View

1. Output speed sensor 2. O-ring 3. Transaxle assembly Front

Removal and Installation

REMOVAL

  1. Remove the front LH wheel and tire.
  2. Disconnect the harness connector from output speed sensor.
  3. Remove the output speed sensor.
  4. Remove the O-ring from the output speed sensor.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Do not reuse O-ring.
  • Apply Genuine NISSAN Matic S ATF to the O-ring.

Inspection and Adjustment

INSPECTION AFTER INSTALLATION

Check for A/T fluid leakage. Refer to TM "Inspection".

ADJUSTMENT AFTER INSTALLATION

Check the A/T fluid level. Refer to TM "Adjustment".

Oil pan

Exploded View 1. Transaxle assembly 2. Oil pan gasket 3. Magnet 4. Oil pan 5. Overflow tube 6. Drain plug gasket 7. Drain plug 8. Oil pan fitting bolt Removal and Installation REMOVAL R ...

Differential side oil seal

Exploded View 1. Transaxle assembly 2. Differential side oil seal (left side) 3. Differential side oil seal (right side) Front Genuine NISSAN Matic S ATF Removal and Installation NOTE: W ...

Other materials:

Meters and gauges
Type A (if so equipped) 1. Tachometer 2. Speedometer 3. Fuel gauge 4. Odometer Twin trip odometer Trip computer 5. Continuously Variable Transmission (CVT) position indicator (if so equipped) Automatic Transmission (A/T) position indicator (if so equipped) 6. Instrument brightness con ...

Push-button ignition switch (if so equipped)
WARNING Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive times in quick succession or the ignition switch is pushed and held for more than 2 seconds.) If the engine stops ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0107