OUTSIDE HANDLE : Removal and Installation
REMOVAL
1. Remove the outside handle. Refer to DLK "OUTSIDE HANDLE : Removal and Installation".
2. Remove the handle cover screw, handle cover and door antenna.
INSTALLATION
Installation is in the reverse order of removal.
REAR BUMPER : Removal and Installation
REMOVAL
1. Remove the rear bumper fascia. Refer to EXT "Removal and Installation".
2. Remove clips (A) and the outside key antenna (rear bumper) (1).
INSTALLATION
Installation is in the reverse order of removal.
INTELLIGENT KEY WARNING BUZZER
Removal and Installation
REMOVAL
Remove bolt (A) and the Intelligent Key warning buzzer (1).
INSTALLATION
Installation is in the reverse order of removal.
REMOTE KEYLESS ENTRY RECEIVER
Removal and Installation
REMOVAL
1. Remove the glove box. Refer to IP "Removal and Installation".
2. Remove the remote keyless entry receiver bolt (A).
3. Disconnect the harness connector from remote keyless entry receiver and remove remote keyless entry receiver (1)
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation 1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key. 2. Insert a suitable tool (A) wrapped with a cloth into the slit of the corner ...
Slip indicator lamp
Component Function Check
1.CHECK SLIP INDICATOR LAMP FUNCTION
Check that slip indicator lamp in combination meter turns ON for
approximately 2 seconds after ignition switch
is turned ON.
Is the inspection result normal?
YES >> Inspection End.
NO >> Proceed to diagnosis procedure. ...
High-pressure flexible hose
Removal and Installation
CAUTION:
Perform oil return operation before each refrigeration system disassembly.
However, if a large amount
of refrigerant or oil is detected, do not perform oil return operation. Refer to
HA "Perform Oil
Return Operation".
REMOVAL
Use refrigerant ...