Nissan Versa (N17): P0607 ECM

Nissan Versa 2nd generation (N17) Service Manual / Engine / Engine control system (EC) / P0607 ECM

DTC Logic

DTC DETECTION LOGIC

DTC No. Trouble diagnosis (Trouble diagnosis content) DTC detecting condition Possible cause

P0607

 ECM (CAN communication bus) When detecting error during the initial diagnosis of CAN controller of ECM. ECM

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.
  2. Check DTC.

Is DTC detected?

YES >> Proceed to EC, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

  1. Turn ignition switch ON.
  2. Erase DTC.
  3. Perform DTC confirmation procedure. Refer to EC, "DTC Logic".
  4. Check DTC.

Is the DTC P0607 displayed again?

YES >> Replace ECM. Refer to EC, "Removal and Installation".

NO >> INSPECTION END

P0605 ECM

P0643 sensor power supply

Other materials:

Cold weather driving
Freeing a frozen door lock To prevent a door lock from freezing, apply deicer through the key hole. If the lock becomes frozen, heat the key before inserting it into the key hole, or use the remote keyless entry key fob or the NISSAN Intelligent Key. Antifreeze In the winter when it is antic ...

Engine stand setting
Setting NOTE: The following procedures explain how to disassemble the engine with the engine stand fastened to the bell housing. Some steps may be different if using a different type of engine stand.     1.   Install engine to engine stand:     a. Rem ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0159