BACK-UP LAMP SWITCH : Component Inspection
1.CHECK BACK-UP LAMP SWITCH

Is the inspection result normal?
YES >> INSPECTION END
NO >> Replace position switch. Refer to TM, "Removal and Installation".

PARK/NEUTRAL POSITION (PNP) SWITCH : Component Inspection
1.CHECK PARK/NEUTRAL POSITION (PNP) SWITCH

Is the inspection result normal?
YES >> INSPECTION END
NO >> Replace position switch. Refer to TM, "Removal and Installation".

NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary, repair or replace these parts.

Structure and operationSectional View 1. Clutch housing 2. 1st-2nd synchronizer hub assembly 3. 3rd-4th synchronizer hub assembly 4. 5th input gear 5. 5th-reverse synchronizer hub assembly 6. 5th-reverse baulk ri ...

Inspection OIL LEAKAGE Make sure that gear oil is not leaking from transaxle or around it. OIL LEVEL Remove filler plug (1) and gasket from transaxle case. Check the oil level from filler pl ...
Standard maintenance
The following tables show the standard maintenance
schedule. Depending upon weather and
atmospheric conditions, varying road surfaces,
individual driving habits and vehicle usage, additional
or more frequent maintenance may be required.
After 120,000 miles
(192,000 km)/144 months, continue m ...
Uniform tire quality grading
DOT (Department of Transportation) Quality
Grades: All passenger car tires must conform to
federal safety requirements in addition to these
grades.
Quality grades can be found where applicable on
the tire sidewall between tread shoulder and
maximum section width. For example:
Treadwear 200 ...