The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SR and SB section of this Service Manual.
WARNING:
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
- Water soluble dirt:
- Oily dirt:
- Do not use organic solvent such as thinner, benzene, alcohol or gasoline.
- For genuine leather seats, use a genuine leather seat cleaner.
PREPARATION
Special Service Tools
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tools
SYSTEM DESCRIPTION
COMPONENT PARTS
Component Parts Location
1. Rod antenna 2. Antenna base (antenna amp.) 3. Rear door speaker RH 4. Front door speaker RH 5. Front door speaker LH 6. Rear door speaker LH 7. Microphone 8. Steering wheel audio control switches 9. Audio unit 10. Bluetooth control unit (view with luggage side lower finisher RH removed) 11. Bluetooth antenna (view with luggage side lower finisher RH removed)
Component Description
Exploded View 1. Antenna mast 2. Antenna base Removal and Installation REMOVAL 1. Remove the headlining. Refer to INT "Removal and Installation". 2. Disconnect the antenna cable. 3 ...
System Diagram System Description AUDIO SYSTEM The audio system consists of the following components Audio unit Front door speakers Rear door speakers Steering wheel audio control sw ...
Expansion valve
Removal and Installation
CAUTION:
Perform oil return operation before each refrigeration system disassembly.
However, if a large amount
of refrigerant or oil is detected, do not perform oil return operation. Refer to
HA "Perform Oil
Return Operation".
REMOVAL
Use refrigerant c ...
Power socket
Exploded View
1. Cap 2. Inner socket 3. Ring
Removal and Installation
CONSOLE POWER SOCKET
Removal
1. Remove the fuse for the power socket.
2. Insert one end of the Tool (A) into one of the square holes inside
the power socket.
Tool number: - (J-42059)
3. Lift up the handle of the ...