Nissan Versa (N17): Push-button ignition switch

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / Push-button ignition switch

Removal and Installation

REMOVAL

1. Remove NATS antenna amp. Refer to SEC "Removal and Installation".

2. Release the push-button ignition switch pawls and remove the push-button ignition switch (1).

: Pawl

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

NATS antenna AMP

Removal and Installation REMOVAL 1. Remove the instrument lower panel LH. Refer to IP"Removal and Installation". 2. Release the NATS antenna amp. pawls and remove NATS antenna amp. (1) ...

Remote keyless entry receiver

Removal and Installation REMOVAL 1. Remove the glove box. Refer to IP "Removal and Installation". 2. Remove the remote keyless entry receiver bolt (A). 3. Disconnect the harness connec ...

Other materials:

Power steering
WARNING If the engine is not running or is turned off while driving, the power assist for the steering will not work. Steering will be harder to operate. When the power steering warning light illuminates with the engine running, there will be no power assist for the steering. You w ...

If your vehicle overheats
If your vehicle is overheating (indicated by an extremely high temperature gauge reading (if so equipped), a red high temperature warning light (if so equipped) ), or if you feel a lack of engine power, detect abnormal noise, etc. take the following steps. WARNING Do not continue to driv ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0063