Nissan Versa (N17): Rear pillar finisher

Nissan Versa 2nd generation (N17) Service Manual / Body interior / Interior (INT) / Rear pillar finisher

REAR PILLAR FINISHER : Removal and Installation

REMOVAL

  1. Partially remove rear body side welt. Refer to INT "BODY SIDE WELT : Removal and Installation".
  2. Remove rear seat cushion. Refer to SE "Removal and Installation - Seat Cushion Assembly".
  3. Remove the rear seat bolster. Refer to SE "Removal and Installation - Rear Seat Bolster".
  4. Release rear pillar finisher clips and metal clips using a suitable tool (A) and remove rear pillar finisher by pulling outward.

: Clip

: Metal clip

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: When installing rear pillar finisher, make sure that clips and metal clips are securely pressed in body holes.

Center pillar upper finisher

CENTER PILLAR UPPER FINISHER : Removal and Installation REMOVAL Remove front shoulder anchor. Refer to SB "SEAT BELT RETRACTOR : Removal and Installation". Remove front body side ...

Rear parcel shelf finisher

Exploded View 1. High-mounted stop lamp 2. Rear parcel shelf finisher 3. Seat belt finisher 4. Seatback latch cover 5. Top tether strap anchor 6. Top tether strap anchor finisher Front Paw ...

Other materials:

If your vehicle overheats
If your vehicle is overheating (indicated by an extremely high temperature gauge reading (if so equipped), a red high temperature warning light (if so equipped) ), or if you feel a lack of engine power, detect abnormal noise, etc. take the following steps. WARNING Do not continue to driv ...

P2760 Torque converter
Description This DTC is detected when the torque converter clutch solenoid valve is electrically normal but the torque converter clutch does not engage. This is not due to an electrical malfunction (circuit open or shorted), but is instead due to a mechanical malfunction (sticking of the con ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0243