Nissan Versa (N17): Interior (INT)
- Precautions
- Squeak and rattle trouble diagnoses
- Front door finisher
- Rear door finisher
- Front pillar finisher
- Kicking plate inner
- Dash side finisher
- Body side welt
- Center pillar upper finisher
- Rear pillar finisher
- Rear parcel shelf finisher
- Floor trim
- Headlining
- Trunk rear plate
- Trunk lid trim
Air mix door cable
AIR MIX DOOR CABLE : Removal and Installation REMOVAL Remove foot duct (LH). Refer to VTL "FOOT DUCT : Removal and Installation". Disconnect air mix door cable from A/C control. ...
Other materials:
Valve oil seal
VALVE OIL SEAL : Removal and Installation
REMOVAL
Remove camshafts.
Remove valve lifters.
Rotate crankshaft, and set piston with valve oil seal to be removed to
TDC. This will prevent the valve
from dropping into cylinder.
CAUTION:
When rotating crankshaft, be careful to avoid ...
Fuel level sensor unit
Disassembly and Assembly
Fuel Level Sender Unit
1. Harness connectors 2. Level sending unit module 3. Fuel temperature sensor
4. Float arm assembly
Disassembly
NOTE:
Before disassembly, note the proper placement of the wires to the correct
terminals and correct wire routing to
the term ...
Categories
- Manuals Home
- Nissan Versa Owners Manual
- Nissan Versa Service Manual
- Video Guides
- Questions & Answers
- External Resources
- Latest Updates
- Most Popular
- Sitemap
- Search the site
- Privacy Policy
- Contact Us
0.0068