Nissan Versa (N17): Dash side finisher

Nissan Versa 2nd generation (N17) Service Manual / Body interior / Interior (INT) / Dash side finisher

DASH SIDE FINISHER : Removal and Installation

REMOVAL

  1. Remove front kicking plate. Refer to INT "KICKING PLATE INNER : Removal and Installation".
  2. Lift up rear end of dash side finisher to disengage metal clip.

: Metal clip

REMOVAL

    3.   Pull back dash side finisher to disengage dash side finisher metal clip and remove dash side finisher.

: Metal clip

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: When installing dash side finisher, make sure that all metal clips are securely pressed into body panel holes.

Kicking plate inner

KICKING PLATE INNER : Removal and Installation FRONT KICKING PLATE Removal     1.   Release front kicking plate pawls using a suitable tool (A) and remove front kicking ...

Body side welt

BODY SIDE WELT : Removal and Installation CAUTION: Do not excessively pull or stretch body side welts. FRONT BODY SIDE WELT Removal Remove dash side finisher. Refer to INT "DASH SIDE FI ...

Other materials:

Exterior front
1. Engine hood 2. Windshield 3. Wiper and washer switch 4. Power windows (if so equipped) 5. Door locks. NISSAN Intelligent Key (if so equipped). Key fob (if so equipped). Keys 6. Mirrors 7. Tire pressure. Flat tire. Tire chains 8. Headlight and turn signal switch. Replacing bulbs 9. Fo ...

P0717 Input speed sensor A
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0717 Input/Turbine Speed Sensor "A" Circuit No Signal Under the following diagnosis conditions, the input speed sensor value is less than 600 rpm continuousl ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0058