Nissan Versa (N17): Body side welt

Nissan Versa 2nd generation (N17) Service Manual / Body interior / Interior (INT) / Body side welt

BODY SIDE WELT : Removal and Installation

CAUTION: Do not excessively pull or stretch body side welts.

FRONT BODY SIDE WELT

Removal

  1. Remove dash side finisher. Refer to INT "DASH SIDE FINISHER : Removal and Installation".
  2. Remove center pillar lower finisher. Refer to INT "CENTER PILLAR LOWER FINISHER : Removal and Installation".
  3. Remove front body side welt.

Installation

Installation is in the reverse order of removal.

REAR BODY SIDE WELT

Removal

  1. Remove center pillar lower finisher. Refer to INT"CENTER PILLAR LOWER FINISHER : Removal and Installation".
  2. Remove rear body side welt.

Installation

Installation is in the reverse order of removal.

CENTER PILLAR LOWER FINISHER

CENTER PILLAR LOWER FINISHER : Removal and Installation

REMOVAL

  1. Remove front kicking plate and rear kicking plate. Refer to INT "KICKING PLATE INNER : Removal and Installation".
  2. Remove center pillar lower finisher as shown.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Dash side finisher

DASH SIDE FINISHER : Removal and Installation REMOVAL Remove front kicking plate. Refer to INT "KICKING PLATE INNER : Removal and Installation". Lift up rear end of dash side finis ...

Center pillar upper finisher

CENTER PILLAR UPPER FINISHER : Removal and Installation REMOVAL Remove front shoulder anchor. Refer to SB "SEAT BELT RETRACTOR : Removal and Installation". Remove front body side ...

Other materials:

Component inspection
Inspection AFTER A COLLISION WARNING: Inspect all seat belt assemblies including retractors and attaching hardware after any collision. NISSAN/INFINITI recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no dam ...

Seat belt retractor
SEAT BELT RETRACTOR : Removal and Installation REMOVAL CAUTION: Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait at least three minutes. Disconnect both the negative and positive battery cables, then wait at least three minutes. Refer to PG " ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0094