Nissan Versa (N17): Trunk lid trim

Nissan Versa 2nd generation (N17) Service Manual / Body interior / Interior (INT) / Trunk lid trim

Exploded View

Exploded View

1. Trunk lid assembly 2. Trunk lid finisher

Removal and Installation

REMOVAL

  1. Fully open trunk lid.
  2. Remove emergency release handle. Refer to DLK "EMERGENCY LEVER : Removal and Installation".
  3. Disconnect the harness connector (A) from the trunk lid lock assembly.
  4. Remove trunk lid finisher clips (B) using a suitable tool and trunk lid finisher.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Trunk rear plate

TRUNK REAR PLATE : Removal and Installation REMOVAL Fully open trunk lid. Remove trunk floor carpet. Remove trunk rear plate clips (A).     4.   Release trunk ...

Precautions

Other materials:

Torsion bar
TORSION BAR : Removal and Installation REMOVAL 1. Remove torsion bar clamp. 2. Support trunk lid with a suitable tool. WARNING: Bodily injury may occur if trunk lid is not supported properly when removing the torsion bars. 3. Apply a torsion bar wrench (A) to torsion bar (1) and lift torsi ...

Inside handle
INSIDE HANDLE : Removal and Installation REMOVAL 1. Remove front door finisher. Refer to INT "Removal and Installation". 2. Remove upper side of sealing screen. NOTE: Cut the butyl tape so that some parts of the butyl tape remain on the sealing screen, if the sealing screen is re ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0066