
The night position 1 reduces glare from the headlights of vehicles behind you at night.
Use the day position 2 when driving in daylight hours.
WARNING
Use the night position only when necessary, because it reduces rear view clarity.
WARNING
You could lose control of your vehicle and cause an accident.
Electric control type

The outside mirror remote control will operate only when the ignition switch is in the ACC or ON position.
Move the small switch 1 to select the right or left mirror. Adjust each mirror to the desired position using the large switch 2.
Manual folding outside mirrors

Pull the outside mirror toward the door to fold it.
Sun visors1. To block glare from the front, swing down the sun visor 1 . 2. To block glare from the side, remove the sun visor from the center mount and swing the visor to the side 2 . 3. Slide the ext ...

WARNING Positioning of the heating or air conditioning controls and display controls should not be done while driving in order that full attention may be given to the driving operation. ...
Trunk lid opener cable
TRUNK LID OPENER CABLE : Removal and Installation
REMOVAL
1. Remove trunk lid striker. Refer to DLK "TRUNK LID STRIKER : Removal and
Installation".
2. Remove trunk side finisher (LH). Refer to INT "TRUNK SIDE FINISHER :
Removal and Installation".
3. Remove rear seat cushi ...
B2267 Engine speed
Description
The engine speed signal is transmitted from ECM to the combination meter via
CAN communication.
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK COMBINATION METER INPUT SIGNAL
1. Start engine and select METER/M&A on CONS ...