NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
VALUES ON THE DIAGNOSIS TOOL
TERMINAL LAYOUT
PHYSICAL VALUES
FAIL-SAFE CONTROL BY DTC
BCM performs fail-safe control when any DTC are detected.
FAIL-SAFE CONTROL OF COMBINATION SWITCH READING FUNCTION CAUSED BY LOW POWER SUPPLY VOLTAGE
If voltage of battery power supply lower, BCM maintains combination switch reading to the status when input voltage is less than approximately 9 V.
NOTE: When voltage of battery power supply is approximately 9 V or more, combination switch reading function returns to normal operation.
DTC Inspection Priority Chart
If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart.
DTC Index
NOTE: Details of time display
WIRING DIAGRAM
BCM
Wiring Diagram
BASIC INSPECTION
Water outlet
Exploded View
M/T models
1. Engine coolant temperature sensor 2. Clamp 3. Gasket
4. Clamp 5. Bracket 6. Clamp
7. Water outlet 8. Clamp 9. Clamp
10. Cylinder block heater (Canada) A. From electric throttle control actuator B.
To radiator
C. From heater core D. To heater core E. To electric ...
Rear door glass
Exploded View
1. Rear door panel 2. Sealing screen 3. Rear door sash
4. Power window motor 5. Regulator assembly 6. Partition sash
7. Partition glass 8. Rear door glass 9. Partition weather-strip
10. Rear door glass run 11. Regulator seal (manual window) 12. Retaining clip
(manual window) ...