Nissan Versa (N17): Removal and installation

Nissan Versa 2nd generation (N17) Service Manual / Engine / Engine control system (EC) / Removal and installation

ECM

Exploded View

ECM / Exploded View

1. ECM bracket 2. ECM  : Vehicle front

Removal and Installation

CAUTION: Perform ADDITIONAL SERVICE WHEN REPLACING ECM. Refer to EC-122, "Work Procedure".

REMOVAL

  1. Remove battery. Refer to PG, "Removal and Installation".
  2. Remove IPDM E/R. Refer to PCS, "Removal and Installation" (WITH I-KEY) or PCS, "Removal and Installation" (WITHOUT I-KEY).
  3. Remove IPDM E/R cover (1).

A : mounting nut

B : mounting bolts

  1. Disconnect ECM harness connectors.
  2. Remove ECM mounting nuts.
  3. Remove ECM from ECM bracket.

INSTALLATION

Install in the reverse order of removal.

ECM / Removal and Installation

Positive crankcase ventilation

Inspection 1.CHECK PCV VALVE With engine running at idle, remove PCV valve from rocker cover. A properly working valve makes a hissing noise as air passes through it. A strong vacuum should be f ...

Service data and specifications (SDS)

Idle Speed    *: Under the following conditions A/C switch: OFF Electric load: OFF (Lights, heater fan & rear window defogger) Steering wheel: Kept in straight-ahead pos ...

Other materials:

Oil pump
Exploded View 1. Rear oil seal 2. Oring 3. Oil pan (upper) 4. Oil pump chain tensioner (for oil pump drive chain) 5. Oil pump drive chain 6. Crankshaft key 7. Crankshaft sprocket 8. Oil pump sprocket 9. Oil pump 10. Oring 11. Oring 12. Oil pan drain plug 13. Drain plug washer 14. Oil pan ( ...

Adjustment of steering angle sensor neutral position
Description Refer to the table below to determine if adjustment of steering angle sensor neutral position is required. Work Procedure ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION CAUTION: To adjust neutral position of steering angle sensor, make sure to use CONSULT. (Adjustme ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0069