Description
The key warning chime does not sound, when all of the following conditions are fulfilled.
Diagnosis Procedure
1.CHECK BCM INPUT SIGNAL
1. Connect CONSULT.
2. Select the DATA MONITOR of BCM(BUZZER) and check the KEY ON SW monitor value. Refer to BCS "BUZZER : CONSULT Function (BCM - BUZZER)".
Is the inspection result normal?
YES >> Replace BCM. Refer to BCS "Removal and Installation".
NO >> GO TO 2.
2.CHECK KEY SWITCH SIGNAL CIRCUIT
Check the key switch signal circuit. Refer to WCS "Diagnosis Procedure".
Is the inspection result normal?
YES >> Replace BCM. Refer to BCS "Removal and Installation".
NO >> Check applicable parts, and repair or replace corresponding parts.
The light reminder warning does
not soundDescription Light reminder warning chime does not sound even though headlamps are illuminated. Diagnosis Procedure 1.CHECK COMBINATION SWITCH (LIGHTING SWITCH) OPERATION Check that the headlamp ...
Malfunction indicator lamp
Component Function Check
1.CHECK MIL FUNCTION
Turn ignition switch ON.
Make sure that MIL lights up.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Go to EC, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC
Check that DTC UXXXX is not display ...
Exhaust system
Exploded View
1. Heated oxygen sensor 2 2. Catalyst cover (upper) 3. Seal bearing
4. Catalyst cover (lower) 5. Spring 6. Spring
7. Mounting rubber 8. Main muffler 9. Ring gasket
10. Center muffler 11. Mounting rubber 12. Seal bearing
13. Exhaust front tube
Removal and Installation
WARNIN ...