TRUNK LID OPENER SWITCH : Description
Trunk lid does not open by trunk lid opener switch operation.
TRUNK LID OPENER SWITCH : Diagnosis Procedure
1.CHECK TRUNK LID SWITCH
Check trunk lid switch.
Refer to DLK "Component Function Check".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CHECK TRUNK LID OPENER ACTUATOR
Check trunk lid opener actuator.
Refer to DLK "Component Function Check".
Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace the malfunctioning parts.
3.REPLACE BCM
Is the result normal?
YES >> Inspection End.
NO >> Check intermittent incident. Refer to GI "Intermittent Incident".
INTELLIGENT KEY : Description
Trunk lid does not open by Intelligent Key remote operation.
INTELLIGENT KEY : Diagnosis Procedure
1.CHECK TRUNK LID OPEN FUNCTION
Check trunk lid open function with trunk lid switch.
Does trunk lid open with trunk lid opener switch?
YES >> GO TO 2.
NO >> Refer to DLK "TRUNK LID OPENER SWITCH : Diagnosis Procedure".
2.CHECK REMOTE KEYLESS ENTRY FUNCTION
Check remote keyless entry function.
Does door lock/unlock with Intelligent Key button?
YES >> GO TO 3.
NO >> Refer to DLK "Diagnosis Procedure".
3.CHECK INTELLIGENT KEY
Check Intelligent Key.
Refer to DLK "Component Function Check".
Is the inspection result normal?
YES >> GO TO 4.
NO >> Repair or replace the malfunctioning parts.
4.REPLACE BCM
Is the result normal?
YES >> Inspection End.
NO >> Check intermittent incident. Refer to GI "Intermittent Incident".
Door does not lock/unlock with intelligent
keyDiagnosis Procedure 1.CHECK POWER DOOR LOCK OPERATION Check power door lock operation. Does door lock/unlock with door lock and unlock switch? YES >> GO TO 2. NO >> Refer to DLK &qu ...

Diagnosis Procedure 1.CHECK POWER DOOR LOCK OPERATION Check power door lock operation. Does door lock/unlock with driver side door lock knob and door key cylinder? YES >> GO TO 2. NO > ...
EVAP leak check
Inspection
CAUTION:
Do not use compressed air or a high pressure pump.
Do not exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP
system.
NOTE:
Do not start engine.
Improper installation of EVAP service port adapter [commercial
service tool: (J-41413-OBD)] to the EVAP ...
Line pressure test
Work Procedure
INSPECTION
Check the engine oil level. Replenish if necessary. Refer to LU
"Inspection".
Check for CVT fluid leaks. Refer to TM "Inspection".
Drive for about 10 minutes to warm up the vehicle so that the CVT fluid
temperature is 50 to 80C (122 to
...