Nissan Versa (N17): Ignition position warning function does not operate

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Ignition position warning function does not operate

Diagnosis Procedure

1.CHECK POWER DOOR LOCK OPERATION

Check power door lock operation.

Does door lock/unlock with driver side door lock knob and door key cylinder?

YES >> GO TO 2.

NO >> Refer to DLK "Diagnosis Procedure".

2.CHECK DOOR SWITCH

Check door switch.

Refer to DLK "Component Function Check".

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.REPLACE BCM

Replace BCM. Refer to BCS "Removal and Installation".

Confirm the operation after replacement.

Is the result normal?

YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI "Intermittent Incident".

Trunk lid does not open

Auto door lock operation does not operate

Diagnosis Procedure 1.CHECK AUTO LOCK SET SETTING IN WORK SUPPORT Select INTELLIGENT KEY of BCM using CONSULT. Select AUTO LOCK SET in WORK SUPPORT mode. Check AUTO LOCK SET setting in WORK ...

Other materials:

Push-button ignition switch (if so equipped)
WARNING Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive times in quick succession or the ignition switch is pushed and held for more than 2 seconds.) If the engine stops ...

Service data and specifications (SDS)
General Specification CAUTION: Use only Genuine NISSAN Matic S ATF. Do not mix with other ATF. Using ATF other than Genuine NISSAN Matic S ATF will cause deterioration of driveability and A/T durability, and may damage the A/T, which is not covered by the warranty. *1: ...

Nissan Versa (N17): Ignition position warning function does not operate

Trunk lid does not open

Auto door lock operation does not operate

Other materials:

Categories