Diagnosis Procedure
1.CHECK AUTO LOCK SET SETTING IN WORK SUPPORT
Refer to BCS "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Set MODE 2, MODE 3, MODE 4, MODE 5, MODE 6 or MODE 7 in AUTO LOCK SET.
2.REPLACE BCM
Is the result normal?
YES >> Inspection End.
NO >> Check intermittent incident. Refer to GI "Intermittent Incident".
Ignition position warning function
does not operateDiagnosis Procedure 1.CHECK POWER DOOR LOCK OPERATION Check power door lock operation. Does door lock/unlock with driver side door lock knob and door key cylinder? YES >> GO TO 2. NO > ...

Diagnosis Procedure 1.CHECK AUTOMATIC LOCK/UNLOCK SELECT SETTING IN WORK SUPPORT Select DOOR LOCK of BCM using CONSULT. Select AUTOMATIC LOCK/UNLOCK SELECT in WORK SUPPORT mode. Check AUTOMAT ...
Service data and specifications
(SDS)
General Specification
CAUTION:
Use only Genuine NISSAN CVT Fluid NS-3. Do not mix with other
fluid.
Use only Genuine NISSAN CVT Fluid NS-3. Using transmission fluid
other than Genuine NISSAN CVT Fluid NS-3 will damage
the CVT, which is not covered by the (NISSAN new vehicle limi ...
High-pressure pipe
Removal and Installation
CAUTION:
Perform oil return operation before each refrigeration system disassembly.
However, if a large amount
of refrigerant or oil is detected, do not perform oil return operation. Refer to
HA "Perform Oil
Return Operation".
REMOVAL
Remove low-press ...