Description
The following functions are available when having and carrying the keyfob.
Remote control entry function and panic alarm function are available when operating the remote buttons.
NOTE: The Signal Tech II Tool (J-50190) can be used to test the remote keyless entry keyfob relative signal strength.
Refer to the Signal Tech II User Guide for additional information.
1.CHECK FUNCTION
With CONSULT
Check remote keyless entry receiver KEYLESS LOCK, KEYLESS UNLOCK, KYLS TRNK/HAT
and KEYLESS PANIC in Data Monitor mode with CONSULT.
Is the inspection result normal?
YES >> Keyfob is OK.
NO >> Refer to DLK "Diagnosis Procedure".
NOTE: The Signal Tech II Tool (J-50190) can be used to test the remote keyless entry keyfob relative signal strength.
Refer to the Signal Tech II User Guide for additional information.
1.CHECK KEYFOB FUNCTION
Check keyfob function using Signal Tech II Tool J-50190 or Remote Keyless Entry Tester J-43241 (shown).
Does the test pass?
YES >> Keyfob is OK.
NO >> GO TO 2
2. CHECK KEYFOB COMPONENTS
CAUTION: Do not touch the circuit board or battery terminal. The keyfob is water-resistant. However, if it does get wet, immediately wipe it dry.
CAUTION: Keep dirt, grease, and other foreign materials off the electrode contact area.
Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace malfunctioning parts.
3.CHECK KEYFOB BATTERY
Check by connecting a resistance (approximately 300Ω) so that the current value becomes about 10 mA.
Standard : Approx. 2.5 - 3.0V
Is the measurement value within specification?
YES >> Keyfob battery is OK. Check remote keyless entry receiver. Refer to DLK "Component Function Check".
NO >> GO TO 4
4. REPLACE KEYFOB BATTERY
1. Replace the keyfob battery with a new one (CR1620 or equivalent).
CAUTION:
2. Align the tips of the upper and lower parts, and then push them together until it is securely closed.
3. After replacing the battery, check that all keyfob functions work properly.
Is the inspection result normal?
YES >> Keyfob is OK.
NO >> Check remote keyless entry receiver. Refer to DLK "Component Function Check".
Description Receives keyfob operation and transmits to BCM. ...
Description Perform answer-back for each operation with horn. ...
Heater and Air Conditioner (manual)
WARNING
The air conditioner cooling function operates
only when the engine is running.
Do not leave children or adults who
would normally require the assistance
of others alone in your vehicle. Pets
should also not be left alone. They
could accidentally injure themselves or
others ...
Standard maintenance
The following tables show the standard maintenance
schedule. Depending upon weather and
atmospheric conditions, varying road surfaces,
individual driving habits and vehicle usage, additional
or more frequent maintenance may be required.
After 120,000 miles
(192,000 km)/144 months, continue m ...