CAUTION:
REMOVAL
WARNING: Bodily injury may occur if hood assembly is not supported properly when removing hood assembly.
CAUTION: Use two people when removing or installing hood assembly due to its heavy weight.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
1. Hood assembly 2. Hood bumper rubber 3. Hood hinge (LH) 4. Hood lock assembly 5. Front bumper fascia 6. Front combination lamp (LH) 7. Front fender
Check the clearance and the surface height between hood and each part by visual inspection and tactile feel.
If the clearance and the surface height are out of specification, adjust them
according to the adjustment procedure.
ADJUSTMENT PROCEDURE
Check hood lock assembly and primary striker for looseness.
CAUTION: If any looseness is felt in hood striker or hood lock assembly, rotate bumper rubber more than 1/8 of a rotation.
7. Check that primary latch (1) is securely engaged with primary striker (2) when hood is dropped with hood's own weight from approximately 200 mm (7.9 in) height.
8. Close hood assembly with a static closing force of 300 - 490 N (30.6 - 50.0 kg-f, 67.4 - 110 lb-f).
HOOD HINGE : Removal and Installation REMOVAL Remove hood assembly. Refer to DLK "HOOD ASSEMBLY : Removal and Installation". Remove hood support rod and grommet. Refer to DLK " ...
Line pressure test
Work Procedure
INSPECTION
Inspect the amount of engine oil. Replenish the engine oil if necessary.
Refer to LU, "Inspection".
Drive for about 10 minutes to warm up the vehicle so that the A/T fluid
temperature is to 50 to 80C (122
to 176F).
Inspect the amount of ATF. Rep ...
Key interlock cable
Exploded View
1. CVT shift selector assembly 2. Key interlock cable
A: Key cylinder B: Lock plate C: Clip
Removal and Installation
REMOVAL
CAUTION:
Always apply the parking brake before performing removal and installation.
Move the shift selector to the "N" position.
Remove the shi ...